G0783 (Mfd. Since 05/15)
-33-
Adjusting Miter
Lock Lever
The miter lock lever (see
Figure 42) ensures the
swiveling saw base remains locked at a desired
angle during the cut.
Lock lever adjustment components can be
accessed by removing the rear access panel or
through the front storage compartment.
Tools
Needed:
Qty
Hex Wrench 6mm .............................................. 1
Wrench or Socket 14mm ................................... 1
3. Rotate lock lever left or right, as needed.
Re-tighten cap screws and tensioner hex
nuts, and then test lock lever range of move-
ment.
Note: Check lock lever clearance to ensure
it does not interfere with the vise handwheel
rotation when fully locked.
Figure 42. Miter lock lever location
Miter Lock Lever
Vise Handwheel
To adjust lock lever:
1. DISCONNECT SAW FROM POWER!
2. Loosen cap screws securing lock lever arm to
lock bolt shown in
Figure 43.
Figure 43. Miter lock lever adjustment
components.
Lock
Bolt
Lock
Lever
Arm
Tensioner
Hex Nut
(1 of 3)
Cap
Screw
(1 of 3)
Summary of Contents for G0783
Page 48: ......