Grizzly G0783, Owner'S Manual, Page: 19 / 48

G0783 (Mfd. Since 05/15)
-17-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Verify gearbox is filled with oil. Refer to
Step 3 of Assembly on Page 15.
3. Press Emergency Stop button.
4. Connect machine to power source.
5. Turn master power switch to "1" (ON)
position (see Figure 14).
6. Turn speed range switch to "1"
( see
Figure 14).
7. Rotate Emergency Stop button (see
Figure 15) clockwise to reset.
Figure 14. Switch identification.
Speed
Range
Switch
Emergency
Stop
Trigger
Button
Master
Power
Switch
8. Turn cutting fluid valve to open position (see
Figure 2 on Page 4).
9. Press trigger button on lever arm. Cutting
fluid should begin flowing onto blade.
10. Motor should run smoothly and without unu-
sual problems or noises.
—Address strange or unusual noises by
referring to
Troubleshooting on Page 31
for help.
—Always disconnect machine from power
when investigating or correcting potential
problems.
11. Turn machine OFF by releasing trigger
button.
12. Press Emergency Stop button, then press
trigger button. Saw should not run.
If saw does start, immediately disconnect
power to saw. The Emergency Stop button is
not working properly. The safety feature must
work properly before proceeding with regular
operations. Call Tech Support for help.
Figure 15. Resetting emergency stop button.