Model G0745 (Mfg. Since 11/13)
-35-
backlash Adjustment
Backlash is the amount of free-play in the lead-
screws. it can be felt while changing rotation
directions with the cross slide and longitudinal
feed handwheels. Before beginning any adjust-
ment, make sure all associated components are
cleaned and lubricated, and the locks are loose.
Carriage
Tools Needed:
Qty
hex Wrench 5mm .............................................. 1
the carriage handwheel backlash is adjusted with
the leadscrew supports (see
figure 39).
figure 39. Carriage adjustment screws and
leadscrew supports.
supports
Cap screws
Reducing backlash to less than 0.002" is
impractical and can lead to accelerated wear
in the leadscrew and other components.
Avoid the temptation to overtighten the
backlash nut or screw while adjusting.
Cross Slide
Tools Needed:
Qty
phillips head screwdriver #1 ............................. 1
the cross slide backlash is adjusted by loosening
phillips head screw (see
figure 38). When the
screw is tightened, the leadscrew nut draws the
leadscrew up, removing free-play.
to adjust the backlash, move the tool post out
of the way, or remove it. then, rock the cross
slide handwheel back and forth, and tighten the
screw slowly until the backlash is approximately
0.002"–0.003" as indicated on the graduated dial.
if you end up adjusting the nut too tight, loosen
the screw, turn the handwheel back and forth until
it turns freely—then try again.
figure 38. Cross slide backlash adjustment
screw.
adjustment
screw
to access the leadscrew supports, remove the
leadscrew cover. loosen the four cap screws,
push the leadscrew supports towards the center
of the lathe, then tighten the cap screws. turn the
handwheel—backlash should be approximately
0.002"–0.003" as indicated on the graduated
dial. if the adjustment is too tight, loosen the
cap screws, and re-adjust the supports until the
handwheel turns freely. re-install the leadscrew
cover when finished.
Summary of Contents for G0745
Page 44: ... 42 Model G0745 Mfg Since 11 13 Figure 47 Circuit board ...
Page 52: ......