-38-
Model G0634Z/G0634XP (Mfd. Since 01/20)
To convert the machine for jointer operations:
1.
Lower planer table to below 4" mark on thick-
ness scale.
2.
Reverse
Steps 2–8
in previous subsection,
beginning on
Page 37
.
Note: Make sure to lower the planer dust
port to the DOWN position, as shown in
Figure 42.
Note: In order to lower jointer tables for
jointer operations, you must pull the jointer
table release knobs up to release tables (see
Figure 42).
Figure 41
. Example of machine converted to
planer.
Planer Dust
Port
7.
Swing planer dust port clockwise over
cutterhead and connect dust collection hose,
as shown in
Figure 41
.
8.
Move jointer/planer selection lever to up posi-
tion (see
Figure 41
).
Figure 42
. Example of planer dust port in DOWN
position and location of jointer table release
knobs.
Serious personal injury could occur if you
place your fingers between the tables and
base or between pivot points. Your hands
could be pinched or crushed!
Planer Dust Port
DOWN
Jointer Table
Release Knobs
Selection
Lever
In Up
Position
Summary of Contents for G0634Z insert
Page 92: ......
