Grizzly G0580, Owner'S Manual, Page: 19 / 64

Model G0580 (Mfd. Since 11/06)
-17-
Components and Hardware Needed: Qty
Carriage Bolts M8-1.25 x 16 ............................ 34
Hex Nuts M8-1.25 ............................................ 34
Base Plate ......................................................... 1
Legs ................................................................... 4
Side Leg Braces ................................................ 2
Front/Rear Leg Braces ...................................... 2
Support Braces ................................................. 2
Tools Needed: Qty
Wrench or Socket 13mm ....................................1
To assemble the stand:
1. Place the base plate upside down on a flat
surface, and loosely attach the legs to the
base plate with the carriage bolts and hex
nuts.
Note: Install the carriage bolts with the round
end facing out.
2. Loosely attach the front/rear leg braces and
side braces to the legs, then turn the stand
right side up. Make sure it sits level, then
tighten all the hex nuts.
3. Place the support braces on the underside of
the base plate, making sure the hole patterns
match and are properly aligned.
4. Insert a carriage bolt through two end holes
in each brace and loosely secure them, as
shown in
Figure 10.
Assembling Stand
Components and Hardware Needed: Qty
Hex Bolts M8-1.25 x 35 ..................................... 4
Hex Nuts M8-1.25 .............................................. 4
Flat Washers 8mm ............................................ 4
Lock Washers 8mm ........................................... 4
Tools Needed: Qty
Wrenches or Sockets 13mm ..............................2
Main Body
The Model G0580 is a
heavy machine (154 lbs.).
DO NOT over-exert your-
self while unpacking or
moving your machine—
get assistance.
To install the main body:
1. With the help of an assistant, set the body
onto the stand and align the stand holes with
the main body.
2. Have your assistant hold the main body in
place and secure the main body to the stand
(see
Figure 11) with the hex bolts, flat wash-
ers, lock washers, and hex nuts.
Figure 11. Securing main body to the stand.
Figure 10. Carriage bolts in rear holes.