Grizzly G0532, Owner'S Manual

Page: 16 / 36

-14-
G0532 2HP Dry Spray Booth
3. Fasten a long leg support ( Figure 5 ) to the
two legs with four
3
⁄
8
"-16 x
3
⁄
4
" hex bolts, eight
flat washers and four hex nuts.
4. With the help of an assistant, turn the exhaust
fan onto its opposite side.
5.
Install the other two legs and a long leg sup-
port on the other side of the exhaust fan,
repeating
Steps 2-3
.
Note
: Do not completely tighten the hardware
at this time.
6. Fasten a short leg support ( Figure 6 ) to two
legs with four
3
⁄
8
"-16 x
3
⁄
4
" hex bolts, eight flat
washers and four hex nuts.
7. Repeat Step 6 to install the second short
leg support. The stand assembly should now
look like the example shown in
Figure 6 .
Figure 5. Installing a long leg support.
Figure 6. Short leg supports installed.
8.
To install casters onto the legs, go to
Step 9
.
If you prefer not to install casters, go to Step
10
.
9.
Fasten each of the four casters to the bottom
of the each of the legs with four
5
⁄
16
"
-18 x
3
⁄
4
"
hex bolts, eight flat washers and four hex
nuts. Install the fixed casters in front and the
swivel casters in back.
10.
With the help of an assistant, raise the
exhaust fan off of the floor and tighten all
hardware.
11.
Proceed to
Skew Boards on this page
.
Components and Hardware Needed: Qty
Skew Boards (Upper & Lower) .......................... 2
Skew Boards (Right and Left) ........................... 2
Braces (Large) ................................................... 4
Braces (Small) ................................................... 4
Curtain Braces .................................................. 2
Hex Bolts
5
⁄
16
"-18 x
3
⁄
4
" ....................................... 9
Flat Washers
5
⁄
16
" ............................................ 18
Hex Nuts
5
⁄
16
"-18 ................................................ 9
Hex Bolts
1
⁄
4
"
-20 x
1
⁄
2
" ...................................... 24
Flat Washers
1
⁄
4
" .............................................. 72
Hex Nuts
1
⁄
4
"-20 ............................................... 48
Flat Head Screws
1
⁄
4
"-20 x
5
⁄
8
" ......................... 24
To install the skew boards and braces:
1.
Secure the right skew board (
Figure 7
) to the
exhaust fan with three
5
⁄
16
"
-18
x
3
⁄
4
" hex bolts,
six flat washers, and three hex nuts.
Skew Boards
Long
Leg
Support
Figure 7.
Installing right skew board.
Right
Skew
Board
Short
Leg
Supports