Grizzly G0530, Instruction Manual, Page: 8 / 24

-6- G0530 Variable Speed Buffer
SECTION 3: CIRCUIT REQUIREMENTS
A fire may occur if your particular electrical
configuration does not comply with local and
state codes. The best way to ensure compli-
ance is to check with your local municipality
or a licensed electrician.
Your Shop Circuit Capacity
Always check to see if the wires in your circuit
are capable of handling the amperage draw from
your machine, as well as any other machines that
could be operating on the same circuit. If you are
unsure, consult a qualified electrician.
Figure 1. Typical locking type L15-30 plug and
receptacle.
Serious personal injury could occur if you
connect your machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
Wiring
The Model G0530 is prewired for 220V 3-phase
operation.
Amperage Draw
The Model G0530 has a 5 HP motor that will draw
the following amps at 220V 3-phase:
Buffer Motor ...........................................15 Amps
Circuit Breaker Requirements
Install the machine on a dedicated circuit to
reduce the possibility of overloading the circuit
and tripping the circuit breaker.
If the circuit breaker trips and the circuit is of the
correct load capacity, have the circuit inspected
by qualified electrician. Never use a larger circuit
breaker than stated below, or you will increase
the risk of fire.
Circuit Breaker ............................ 15 Amp, 3 Pole
Minimum Cord Requirements
For 220V 3-phase operation, use the following
type of cord (a cord is not provided):
Cord ................................................3 pole, 4 wire
Gauge .............................................................. 14
Plug Type
The plug you install on your cord will depend upon
the type of service you currently have or plan to
install. We recommend using the following plug
and receptacle for your machine on a dedicated
circuit only (see
Figure 1
for an example):
Plug & Receptacle ................................... L15-30
220V 3-Phase