Grizzly G0524, Owner'S Manual, Page: 34 / 60

-32-
Model G0524 (Mfd. Since 7/16)
To adjust the feed motor V-belt tension:
1. Disconnect the saw from the power
source!
2. Remove the side access panel to reveal the
adjustment mechanism.
3. Loosen the jam nut (Figure 38).
To adjust the ride height of the fence:
Adjust the setscrew ( Figure 39) to raise and lower
the ride height of the fence. Note—The fence
could scratch the steel table surface if the ride
height is set too low.
Figure 39. Fence ride height adjustment.
4. Raise or lower the adjustment nut to change
the V-belt tension. Note—Raise the adjust-
ment nut to decrease the tension and lower
it to increase the tension.
5. Retighten the jam nut when the V-belt has
been tensioned correctly and re-install the
side access panel.
Figure 38. Feed motor V-belt adjustment.
Adjustment
Nut
Jam Nut
Fence Ride Height