Grizzly G0524, Owner'S Manual, Page: 22 / 60

-20-
Model G0524 (Mfd. Since 7/16)
Figure 20. Connecting power to machine.
Move the disconnect switch handle to the ON
position, as illustrated below. The machine is now
connected to the power source.
Connecting to Power Source
Figure 21. Disconnecting power from machine.
Move the disconnect switch handle to the OFF
position, as illustrated below. The machine is now
disconnected from the power source.
Note: Lock the switch in the OFF position to
restrict others from starting the machine.
Disconnecting from Power Source
Figure 18. Location to connect incoming ground
wire on grounding plate.
4. Connect incoming power wires to top R, S, T
terminals shown in
Figure 19.
Figure 19. Terminal locations to connect
incoming power wires.
Incoming
Power
Terminals
3. Connect ground wire to ground terminal
shown in
Figure 18 on grounding plate.
5. Make sure wires have enough slack so they
are not pulled tight or stretched.
6. Close and secure electrical access door, then
REMOVE BLADE , and perform Test Run.
2. Insert incoming power wires where strain
relief is located on side of electrical access
door.
Incoming
Ground
Terminal
For Phase
Converter
Wild Wire (If
Used)
Grounding
Plate