Grizzly EASY FEEDER, Owner'S Manual

Page: 30 / 44

-28-
Model G0826 (Mfd. Since 01/17)
Items Needed Qty
NLGI#2 Grease or Equivalent ........... As Needed
ISO 32 Oil or Equivalent .................... As Needed
Clean Shop Rags .............................. As Needed
Mineral Spirits .................................... As Needed
Brushes ............................................. As Needed
1-Gallon Catch Pan ........................................... 1
Grease Gun ....................................................... 1
Open-End Wrench 14mm .................................. 1
Open-End Wrench 22mm .................................. 1
Hex Wrench 5mm .............................................. 1
Roller & Chain Grease Fittings
Lube Type ............. T26419 or NLGI#2 Equivalent
Amount ............................................. 1–2 Pumps.
Lubrication Frequency .......200 Hrs. of Operation
Grease Gun ....................................................... 1
Wipe the roller and chain grease fittings clean and
lubricate with one pump from a grease gun filled
with NLGI#2 grease (see
Figures 36–37). It will
be necessary to remove the chain cover to access
the chain grease fittings.
Figure 36. Location of roller grease fittings.
Grease Fittings
Figure 37. Location of chain grease fittings
(chain cover removed).
Grease Fittings
Gearbox
Lube Type .................................80-90W Gear Oil
Amount ...................................................4.05 Oz.
Lubrication Frequency:
•
200 Hrs./First Month of Operation
• 1000 Hrs./6 Months of Operation
The gearbox should be drained and refilled after
the first month or 200 hours of use. For the
remaining life of the power feeder, change oil
every six months or 1000 hours of use.
To change gearbox oil:
1. DISCONNECT MACHINE FROM POWER!
2. Rotate power feeder off of machine table,
remove chain cover, and tighten rotation lock.
3. Rotate power feeder upside down so chains
face down (see Figure 38).
4. Place drain pan under fill plug labeled "OIL,"
then remove fill plug (see
Figure 38) and
drain oil.
5. Rotate power feeder 180 degrees so chains
are face up, then fill gearbox with oil until oil
level is at halfway point in sight glass, then
replace fill plug.
6. Re-install chain cover and rotate power feed-
er back into place for operation.
Figure 38. Location of gearbox fill plug/oil drain
and sight glass.
Oil Sight
Glass
Fill Plug