Grizzly EASY FEEDER, Owner'S Manual

Page: 21 / 44

Model G0826 (Mfd. Since 01/17)
-19-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
4. Connect machine to power supply. Variable-
speed readout (see
Figure 18) will illuminate.
Figure 18. Variable-speed readout illuminated,
indicating power is connected.
Variable-Speed Readout
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Make sure power feeder gearbox oil level
is full. Refer to Lubrication on Page 28 for
details.
3. Adjust and lock power feeder so rollers are
held approximately 1" above machine table
and nothing will interfere with roller rotation.
The test run verifies the motor and control panel
features work correctly prior to regular operation.