8
©Alcor 2011 All rights reserved
The Controls
The depth control (see Fig. 4 and Fig. 5) is located on the right side of the handle assembly. Figure 4 shows the control in the
idle position and figure 5 shows the cutting position. Turning the crank clockwise adjusts the cutting depth lower; counter-
clockwise rotation of crank raises the cutting blade. Operator must be familiar with operation of this control before using
roof cutter on the job.
The throttle is located on the left hand side (see Fig. 6). Lowering lever handle decreases the engine speed. Raising the lever
increases the engine speed.
The throttle is located on the left hand side (see Fig. 6). Lowering lever handle decreases the engine speed. Raising the lever
increases the engine speed.
Be sure to test the shut-off switch before depending on it (see Fig. 7), the shut-off switch is located on the back-side of Honda
engine.
Fig. 6 Throttle control
Fig. 5 Depth control in operating position
Fig. 4 Depth control in idle position
Fig. 7 shut-off switch
