Grizzly Tools B-49396, Translation Of The Original Instructions For Use

Page: 89 / 196

89
GB
Off: Release the drive catch ( 2)
The equipment stops.
Working Instructions
• As far as possible, mow the lawn
when it is dry in order to protect the
turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos -
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during longer
breaks and for transportation and wait
until the blade is stationary.
• Clean the equipment after each use,
as described in the “cleaning and
maintenance“ chapter.
Cleaning and
Maintenance
Have any repair and mainte -
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly Tools replace -
ment parts. Risk of accidents!
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
For cleaning and maintenance
work, also observe the Briggs &
Stratton instruction manual sup -
plied.
We recommend contacting an au -
thorised Briggs & Stratton dealer
for maintenance work on the en -
gine.
You can find a dealer near you
here:
https://www.briggsandstratton.com/
na/en_us/support/dealer-locator.
html.
Cleaning and General Mainte-
nance Work
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
• Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine
as it could contaminate the fuel sys -
tem.
• To clean the blade housing, it is possi -
ble to connection a hose to the upper
side of the housing (29) (see ).
• After mowing, remove plant remains
that are stuck to the equipment by us -
ing a piece of wood or plastic. Clean
the vent holes, ejection hole and blade