GoboLED 500 - Rev. 1.4
page 9 of 20
>Main
Utility
ENTER
Utility
Shut-off time
Utility
Fan mode
Utility
Heater
Utility
Fixture reset
Utility
Default settings
Utility
Calibration
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
UP
DOWN
ENTER
Shut-off time
OFF
Shut-off time
1 minute
UP
DOWN
Shut-off time
5 minutes
UP
DOWN
Shut-off time
60 minutes
UP
DOWN
ENTER
ENTER
ENTER
ENTER
It sets the idle time after which
the display turns off.
AUTO *
HIGH
ENTER
ENTER
It sets the speed of the fan:
AUTO: the speed is controlled
by the internal sensor.
HIGH: the fan runs always at its
maximum speed
UP
DOWN
ENTER
>Heater
TP Control
Fixture reset
Gobo reset
ENTER
UP
DOWN
It resets the position of all gobo wheels.
ENTER
Default settings
RESET ?
ENTER
ENTER
It resets the fixture to factory
default.
Password
xxxx
ENTER
Reserved to service.
>Heater
Open
UP
DOWN
ENTER
ENTER
Fixture reset
Colour reset
Fixture reset
Other reset
UP
DOWN
ENTER
It resets the position of the color wheel.
ENTER
continues on the
next page
The functioning of the heater is
is controlled by the internal sensor.
This setting put the heater always on
to check if the heater works properly.
If the projector is switched off, when it is
turned on again it will be in
“Heater TP Control” as default.
