GoboLED 500 - Rev. 1.4
page 15 of 20
Gobos replacing ( rotating gobo wheel )
WARNING ! Disconnect the unit from mains supply prior to servicing.
Undo the six screws to remove
the cover.
Lift the desired gobo holder.
Put the tool provided along with
the unit under the gobo holder
as shown above.
Pull out the gobo holder.
Ø27 mm ( max size of the gobo )
Ø22 mm (max size of the image)
Gobo Led 500’s gobos must
comply with the above reported
sizes.
Locate the rotating gobo wheel.
The gobo holder must perfectly
fit in its slot.
1
2
3
4
5
6
7
8
At the end of the operations, close
the cover by well cross-tightening
the screws.
Put the new gobo in its slot,
make sure that its flat side goes
under the spring beneath the
cog wheel.