GoboLED 500 - Rev. 1.4
page 14 of 20
Configuration example
A
B
B
B
B
C
A= DMX controller
B= 100-240 VAC 50/60 Hz
C= 120 Ω DMX Terminator
DMX IN
DMX OUT
DMX IN
DMX OUT
DMX IN
DMX OUT
DMX IN
DMX OUT
Fixture 1
DMX Addr: 001
Fixture 1
DMX Addr: 014
Fixture 1
DMX Addr: 027
Fixture 1
DMX Addr: xxx
WARNING ! Use a DMX repeater on each 32nd fixture of the daisy-chain or in case the total DMX cable lenght
exceeds 300m ( 1000 ft.). Install a data terminator ( 120Ω) on the DMX out cable of the last unit of the daisy-chain
as described in the DMX connection kit manual.
GoboLed 500 is provided with an intelligent heating/cooling system that allows to operate also
in very cold ( down to -30°C /- 40°F) or hot ( +50° / 122 °F) environments. When powered on
at very low temperatures, the unit takes some minutes to reach the optimal internal tempera-
ture and to allow proper operation. At normal temperatures the cooling fan may start and stop
automatically due to the internal temperature management system that prevents the LED from
overheating .
Heating and cooling system notice
*DMX cable type: 2x0.34 mmq impedance 110Ω, capacity 43pF/m, resistance 50Ω/Km.
WARNING ! Do not cover or obstruct any of the ventilation grid placed on the fixture. It is highly recommended
regularly to inspect and clean these grids. The obstruction of the grids can seriously compromise the proper
operation of the unit.
WARNING!
Being a mechanical equipment, it could possibly have a variation in the holographic reproduction of about 10cm
(0.33 ft) on 3000cm (98.40 ft)
