Greystone DataFast D-101, User Manual

Page: 31 / 36

D-101 DataFast User’s Manual 4-5
Remote Operation
The status line on the PC screen displays “Disk is free,” “Disk is idle,”
“Disk is reading,” or “Disk is writing,” depending upon current job status.
You can return to the main remote menu whenever the “Disk is free” by
pressing the <
Esc > key. The < Esc > key is disabled whenever a D-101
disk operation has reserved the current selected local hard drive and the
drive is reading, writing, or is idle.
4-2.2 Select Remote Drive
When the remote software is started, it will default to use local IDE hard
drive 0 for remote operation with the D-101. Normally drive C: is
connected to primary IDE port 0 as the master drive, while the DOS letter
assigned to other drives are not predictable. This menu allows the user to
select one of four local physical hard drives that may be cabled to the
internal IDE ports.
PC Screen:
Select a drive by using the arrow keys to highlight the desired drive
number, then press <
Enter >. Press < Esc > to return to the main menu and
retain the displayed selection.
Select Remot Drive
Use cursor keys to highlight activity.
Press <F1> or <ENTER> to make selection.
-----------------------------------------
Drive 0 (Master on primary IDE 0) Selected
Drive 1 (Slave on primary IDE 0)
Drive 2 (Master on secondary IDE 1)
Drive 3 (Slave on secondary IDE 1)
Fri, 09 Jul 1999 09:35:27 AM
Status: Select using cursor keys Press <ESC> to Exit.