(See Drawing on Page 33, pictures on
Page 34)
1.
Lay down the vent gutter with the
punches facing up towards you.
2.
Glass bars with sliders are for the end.
Lay them down with the bolt slot
facing up.
3.
Lay the vent hinge with the punches
facing up towards you.
4.
Slide the bolts into both ends of the end
bar
(1/4” x 3/8”)
. Take the gutter and
line up the bolt with the first punch,
slide the bolt down and tighten it. Do
the same with the hinge, the other side
and center bar. Make sure that the Glass
bars fit tightly into the gutter and hinge
after the vent is assembled.
5.
Turn it over and square it up.
6.
Put the 1/8” foam on the Glass bars and
Gutter.
7.
Take the glass
and slide it up into the
hinge track. Drop it down on the gutter.
Do the same with the next piece of glass.
8.
Take the caps and lay them on the bars,
center them and screw them on with a
3/4” screw.
9.
Take the silicone gun and seal where the
glass slides into the hinge
.
10. 3/4” screw through hinge and gutter
into glass bars
.
VENT INSTALLATION
Take the vent and slide it into he end of
the ridge
(See Picture
A
)
.
After you remove the screw in the ridge,
push it into place and put the screw
back in
(See Picture
B
)
. Now attach the
automatic opener.
– 33 –
T R A D I T I O N A L S E R I E S S T R A I G H T L E A N T O M O D E L • G R E E N H O u S E I N S T R u c T I O N S
A
B
Vent Assembly
