C R O S S C O U N T R Y F I V E - W A L L S E R I E S S T R A I G H T L E A N T O • G R E E N H O U S E I N S T R U C T I O N S
– 27 –
SIDEWALLS
Take side panels and peel back the protective plastic. Mark the outside top
corner with a marker – apply foil tape, ventilated for the bottom / solid for
the top
(you can do all the panels before hand or 1 at a time)
. After the tape
is applied, take an aluminum “ ” and put it on the top first
(see Picture
A
)
. Remember to remove the paper from the foam strips. On a hot day
lightly spray the foam with water so the polycarbonate sheets / glass will
not stick when you install the panels. Next put one on the bottom
(put in
setting blocks – donot cover drain holes – see Picture
B
)
and push the panel
up behind the gutter edge. Push the panel against the foam, make sure the
Greenhouse is square and screw on the cap using #8 x 3/4” screws. If the
weather is calm you can position all the panels first and then fasten all the caps.
POL
YCARBONA
TE SHEET
POL
YCARBONA
TE SHEET
Base
Setting
Block
A
B
