Greenhouse Style Five-Wall Series, Instructions Manual

Page: 13 / 52

Front Gable End Assembly
Lay out the front pieces into the shape of an end wall. The doorframe and all Poly Bars have a track
for the bolts. The track must face up towards you when you assemble the gable ends. Slide the
bolts in to the ends or use the notches that are punched out in the Poly Bars. Refer to the line/detail
drawings when assembling. (
the sketches/drawings/pictures are viewed from inside the greenhouse).
– 12 –
C R O S S ฀ C O U N T R Y ฀ F I V E - W A L L ฀ S E R I E S ฀ S T R A I G H T ฀ L E A N ฀ T O ฀ • ฀ G R E E N H O U S E ฀ I N S T R U C T I O N S
•฀ ฀Bolt฀the฀bottom฀plates฀(4฀holes)฀to฀
the base/sill and the doorframe sides
using 1/4” x 1/2” stainless steel bolts
(see Picture
A
,
B
and Sketch 1, page
10). Before tighten ing the bolts, be
sure that it is square. (If you ordered
a greenhouse with a door drop, measure
from the bottom of the doorframe to the
underside of the base according to the
specified distance.)For door drop See
Picture
E
and Picture
F
•฀ ฀At฀the฀top฀of฀the฀doorframe,฀put฀on฀
the doorframe header (which looks
the same as the side pieces). Put the
header
between the two side pieces
and bolt on the plates (6 holes) (See
Picture
F
and Sketch 2, page 10). Use
the 2 oblong holes to fasten doorframe to
header.
The plates should stick up 1”
above the doorframe. Note how the
plates are put on. Before tightening
the bolts, be sure to square up the
doorframe.
•฀ ฀Take฀the฀corner฀post฀(angle฀cut฀on฀
top) and bolt it to the base (See
Picture
D
and Sketch 3, page 10).
Top
Side
Corner
Post
Base
A B
C
D
E F