3
GENERAL INSTRUCTIONS FOR SAFETY OPERATION
The operator must obey the local regulations of cutting area.
Never carry the unit with the engine running.
For safety, the unit should not run in full throttle without any load.
Don’t run the unit without a muffier.
During a heavy work, be always with a partner.
When making a repair or adjustment, the unit must be stopped and the fuel completely drained.
For Long-term Storange
Drain all fuel from the carburetor, fuel tank and fuel lines.
Repair any damage which has resulted from use.
Clean the unit with a clean rag, or the use of high pressure air hose.
Put a few drops of engine oil into the cylinder through the spark plug hole, and spin the engine
over several times to distribute oil, then reinstall the spark plug.
Cover the unit and store it in a dry area.
Brush Cutter is composed of three major units;engine, flexible shaft and drive shaft.
1. Assembling drive shaft (Fig. I)
Insert the flexible shaft into the joint pipe of Drive Shaft to the end and tighten the joint pipe bolt
by engaging the bolt to the slot of flexible shaft.
NOTE:Make sure to align square end of flexible inner shaft with square hole of drive shaft by
slightly rotating drie shaft. So that they arc connected firmly.
2. Assembling flexible shaft (Fig.2)
Remove temporarily installed PIN. Insert flexible shaft into clutch case to the end by inserting
square end of flexible inner shaft into square hole of adaptor m Clutch Case. Then screw-in the
PIN by engaging the pin the slot of flexible shaft.
