53
9.14 Parameter Setting Menu
To set PCB parameters proceed as follows:
1.
Press
and
together for about 6 seconds, the
display shows "PO1" alternating with its valve (01);
2.
The parameter setting menu is divided in pages, each with
10 parameters (i.e. Px0-Px9).
3.
: short push to go to the next page (e.g. from
P10-P19 page to p20-P19 page).
4.
: short push to go to the previous page (e.g. from
P20-P19 page to P10-P19 page)
5.
Address/Page Knob:
turning Left Knob permits scrolling
between the parameter within the current selected page.
6.
If
Data Knob
(Right Knob) is moved, "NOP" is seen on
the display to inform the user that moving the Data Knob
has no consequences
NOP= N
o
OP
eration.
7.
short push: parameter visualized in display is
selected and the board goes in the Value setting menu.
8.
: short push to go to next page (e.g. from values 10-
19 page to 20-29 page)
9.
: short push to go to previous page (e.g. from values
20-29 page to 10-19 page)
10.
Data Knob: turning Right Knob permits scrolling the
values in the current selected page.
11.
: short push to save the value visualized on the
display and return to parameter setting menu.
12.
Address/Page Knob: returns to Parameter setting menu
without saving the current value (escape function).
This function ends after 3 minutes, or by pressing
and
simultaneously with a long push.
PN 240012369, REV A [08/31/2018]
9 - START UP PROCEDURE
