OPERATION
29
500ze YM180 (11
−
2012)
PRE
−
OPERATION CHECKLIST
Raise the hopper and engage the hopper safety
arm before performing the pre
−
operation checks.
See the RAISING / LOWERING THE HOPPER
section of this manual.
WARNING: Raised hopper may fall.
Engage hopper safety arm.
NOTE: Do Not unlock the hopper lid latches when
raising the hopper for pre
−
operation checks.
-
Check the machine for fluid leaks.
-
Check the windshield washer fluid level.
-
Ensure battery locks are properly engaged
-
Ensure battery battery isolation button
functions properly and that the lock holds the
battery isolation button down in the engaged
position.
-
Check the hydraulic fluid level.
-
Check the water tank level.
-
Check the condition of the brushes. Remove
any string, banding, plastic wrap, or other
debris from the brushes.
-
Check the vacuum head height and side
skids.
-
Check tire pressure and condition of tires.
-
Check operating lights (headlights, taillights,
work lights, rotating beacon, and hazard
warning lights).
-
Check safety equipment.
-
Ensure all panels are secured in place.
-
Ensure both battery packs are fully charged.
(Both battery packs must be fully charged
before the machine is used).
-
Ensure all controls, gauges, and indicators
function properly.
POST
−
OPERATION CHECKLIST
Completely clean the machine after every use.
Raise the hopper and engage the hopper safety
arm before cleaning the hopper and the battery
compartment. See the RAISING / LOWERING
THE HOPPER section of this manual.
WARNING: Raised hopper may fall.
Engage hopper safety arm.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, place drive
lever in neutral, set parking brake, turn off
machine, and remove key.
-
Empty the hopper.
-
Clean the interior of the hopper.
NOTE: Do Not use excessive water or water
pressure when cleaning areas around the battery
packs.
-
Clean the area around the hydraulic
components.
-
Clean the area surrounding the water pump.
-
Clean the brushes and vacuum head area.
-
Clean the vacuum fan assembly.
-
Fully charge both battery packs when finished
using the machine. Both battery packs must
be fully charged before the machine is again
operated. Do not allow the battery packs to be
discharged below 15%.
ATTENTION!: Battery packs damaged as a
result of being discharged below 15% will not
be covered under warranty.
