Green Energy Inverter Eco 10, User And Service Manual

Page: 17 / 62

14
shows the inlet water temperature and the operation mode.
Press to stop the heat pump unit and show “OFF”
Notice : During the parameter checking and setting, press the to quick-exit and save the current setting .
Press again to turn on/off the machine.
6.2.2 button
Automatic mode:
Press for 5 seconds to switch to automatic mode.(default:Smart mode)
Press for 5 seconds again to exit automatic mode and switch to heating mode(default:Smart mode)
Note:Under Automatic mode, it is useless to set parameter P1 .
Operation logic of Auto Mode:
Set water temperature
(Tset) Current water in
temperature
(Tset +2
℃
)
Current working
mode After 3 minutes or
above, it will switch to
Tset (eg: 28
℃
) Tset +2
℃
(eg:30
℃
) Heating mode
Cooling mode
Tset (eg: 28
℃
) Tset-2
℃
(eg: 26
℃
)
Cooling mode Heating mode
6.2.3 and button
Clock/unclock the display:
Hold and for 5 seconds to lock/Unlock the display.
Water temperature setting :
Press
or
to set the water temperature directly.
Parameter checking :
Press first, then press to check the “ User parameter from d0 to d11
Code Condition Scope Remark
d0 IPM mould temperature 0-120
℃
Real testing value
d1 Inlet water temp. -9
℃～
99
℃
Real testing value
d2 Outlet water temp. -9
℃～
99
℃
Real testing value
d3 Ambient temp. -30
℃～
70
℃
Real testing value
d4 Frequency limitation code 0,1,2,4,8,16 Real testing value