●
This is a general use remote controller. It could be
used for the air conditioner with multifunction. For the
functions which the model doesn't have, if press the
corresponding button on the remote controller, the
unit will keep the original running status.
Auto
Cool
Dry
Heat
Speed 1
Speed 2
Speed 3
Notice
●
There are 3 speeds for the Fan Speed of this model.
●
Cool:
●
Dry:
●
Fan Only:
●
Heat:
●
Introduction for buttons on
remote controller
Swing button
Press this button to turn “ON” & “OFF” swing.
Fan button
Auto
ON/OFF button
Press this button to turn on the unit. Press this button
again to turn off the unit.
MODE button
Fan
Only
Under this mode, air conditioner operates under
cooling mode. Cooling indicator will be on. Press
“Fan Speed” button can adjust the fan speed.
Under this mode, the unit runs in low fan speed
for dehumidification and the corresponding indicator
is on; under dry mode, the fan speed can not be
adjusted.
Under this mode, air conditioner will not cool or
heat, only blow wind. Fan indicator will be on. Press
“Fan Speed” button can adjust the fan speed.
Under this mode, air conditioner operates under
heating mode. Press “Fan Speed” button can
adjust the fan speed.(Cooling only unit won’t re-
ceive heating mode signal. If setting heat mode
with remote controller, press ON/OFF button can’t
start up the unit).
+ / - button
Pressing “+” or “-” button once will increase or dec-
rease set temperature by 1°F(°C). Hold “+” or “-”
button for 2s, set temperature on remote controller
will change quickly.
Release the button after your required set te-
mperature is reached.
Sleep button
Press this button to go into the Sleep operation mode.
Press it again to cancel this function. This function is
available in COOL, HEAT (Only for models with
heating function) mode to maintain the most co-
mfortable temperature for you.
Timer button
Under ON status, press this button to set timer OFF;
Under OFF status, press this button to set timer ON.
Press this button once and the characters of HOUR
ON (OFF) will flash to be displayed. Meanwhile, pr-
ess “+” button or “-” button to adjust timer setting
(time will change quickly if holding “+” or “-” button)
Time setting range is 0.5~24hours. Press this button
again to confirm timer setting and the characters of
HOUR ON (OFF) will stop flashing. If the characters
are flashing but you haven’t press timer button,timer
setting status will be quit after 5s.If timer is confirmer,
press this button again to cancel timer.
Health button
(This function is not applicable for this model. )
Press this button to achieve the on and off of health
and scavenging functions in opreation status. Press
this button for the first time to start scavenging function;
LCD displays " ". Press the button for the second
time to start health and scavenging functions simul-
taneously; LCD displays " " and " ". Press this
Notice
●
Press this button to select your required operation
mode.
Under timer setting status, after each pressing of
“+” or “-” button, time will increase or decrease 0.5h .
Hold “+” or “-” button, 2s later, time displayed on
dual-8 nixie tube will change quickly. Loosen the bu-
tton until the time is reached to your set time.
This button is used for setting Fan Speed in the
sequence that goes from AUTO,
, , to
then back to Auto.
●
Auto:
Under this mode, the unit will operate automatic-
ally according to ex-factory setting. In this case,
set temperature cannot be adjusted.
