❏
1. Cut the 2" x 9" [51 x 229mm] sheet into 3/4" x 1"
[19 x 25mm] pieces.
❏ ❏
2. Trial fit three hinges into each of the ailerons and
install onto the wing panels. Make sure the ailerons work
freely to full deflection.
❏ ❏
3. Hold the aileron to full deflection and place three
drops of thin CA onto each hinge. Flip the wing over and
place three drops onto the other side of each hinge. Be
careful not to use too much CA or it may run down the hinge
line. Exercise the aileron several times to loosen it up.
❏
4. Repeat for the other wing panel.
❏
1. Locate the openings for the flap and aileron servos in
the bottom of each wing panel. Trim out the covering and
seal the edges using a sealing iron.
❏
2. Locate the four servo hatch covers and trim out the
servo arm openings. Seal the edges using a sealing iron.
❏
3. Trial fit your servos onto the covers and mark the
locations of the servo blocks. Note the orientation of the
servos and write the location of each servo on the cover. The
flap servos should be oriented the same for both wing panels.
Install the Aileron and Flap Servos
1" [25mm]
3/4" [19mm]
Trim the Corners
Install the Ailerons and Flaps
WING ASSEMBLY
6
