GREAT PLAINS Yield-Pro Air-Pro YP2425A, Operator'S Manual

Page: 168 / 180

Great Plains | 401-626M | 2019-06-11 Table of Contents Index 164
YP2425A Table of Contents Index Appendix R - Row-Pro™
Row-Pro™ Adjustments
Refer to Figure 168
Load Cell Reading
These readings are displayed and adjusted from the
IntelliAg
®
seed monitor console.
Control Mode: Auto is the normal running mode.
Manual is used to control the valves only when the
operator touches the increase or decrease icon on the
work screen.
Monitor Only : This screen disables control, but still
reports sensor feedback. From there, press the Down
Pressure Diagnostic key and then press the Float
Mode ON button to release all of the air from the system.
Next, press the Float Mode OFF button. Stay on the
Diagnostic screen and make a planting pass. Note the
pressure displayed on the Diagnostic screen and then
evaluate the seed trench. If the seed trench results are
acceptable, use the displayed pressure as your target
rate.
Front-Rear Linked: “ Enabled ” links the front and rear
row units so that the same amount of pressure
increase/decrease set at the screen is applied to
front/rear row units. When “ Disabled ” - front/rear row
units are not linked. Two sets of buttons appear on the
screen that allow for adjustments of front and rear rates
independently.
Target Rate: This is the desired down pressure on the
side depth wheels. The target rate to be entered is the
set rate (pounds) of the down force to determine how
much pressure is applied. The system monitors and
adjusts pressure to meet the defined rate set at this
screen.
 Pressure displayed on screen and target pressure
both refer to the amount of weight carried by the side
depth gauge wheels, and not overall row unit down
pressure.
Inc/Dec: Sets the amount that the Target Rate is
changed with each key press during planting operations.
Figure 168
IntelliAg
®
Screen
36544
1
2
3
Figure 169
Float Mode ON/OFF Screens
2