GREAT PLAINS Yield-Pro Air-Pro YP2425A, Operator'S Manual

Page: 108 / 180

Great Plains | 401-626M | 2019-06-11 Table of Contents Index 104
YP2425A Table of Contents Index Maintenance and Lubrication
Seed Disk Maintenance
Refer to Figure 136
When removing seed disks, inspect them for wear and
damage. If there is any seed dust or treatment build-up in
the cell pockets
, or along the raised wiper ridges ,
clean the disks and reinspect.
Replace disks for conditions including:
•
Chips at circumference . These will leak air.
•
Chips at edges or in sculpted surfaces of cell
pockets
. These can leak air and/or adversely
affect singulation.
•
Cracks over 2 inch (5 cm) long in the working face
of the disk, or any cracks in support webs or to an
edge.
•
Warping - if any part of the disk does not press firmly
on the seed drop brushes (page 81) in operation,
replace the disk.
•
Wear - if a wiper ridge is worn away, replace the
disk. If the seed pockets are worn through, or the air
ports
have enlarged, replace the disk.
Cleaning and Storing Seed Disks
Possible Chemical Hazard:
Wear gloves when washing disks. Avoid spray. Do not wash
disks where food is prepared, or where cookware or
dinnerware is washed. Seed disks will have talc and graphite
residue, and may have residues of hazardous seed treatments.
Although the disks are dishwasher-safe, do not wash them in
an appliance also used for food preparation or food serving
items.
Use warm or hot water, mild soap, and a sponge or soft
brush to remove build-up.
If disks are washed, allow them to dry completely prior to
storage.
Retain original shipping cartons for disk storage.
Otherwise, store them on edge (and not leaning), or
stacked horizontally on a spindle, to eliminate any risk of
warps. Any seed residue on disks may attract pests.
Fully enclose dry disks to prevent rodent damage.
Figure 136
Disk Seed Cells and Wiper
29613
1
2
1
4
5
3
1 2
3
1
4
5