GREAT PLAINS 3N-3010, Operator'S Manual, Page: 80 / 118

76Great Plains | | 4/22/19 Table of Contents Index Great Plains | 76
196-366m Table of Contents Index Veris Drive Operating Instructions

NOTE: If the Veris Console Monitor reads to TIME
TOO LOW or TIME TOO HIGH, you will need to
increase the amount of seed that you will count or
measure. For calibration accuracy, the Controller
Firmware will not allow to calibrate at settings that
would result in the drive rotating for less than 4
seconds or more than 255 seconds.
Refer to Figure 56
14. Press Function key to advance to the next window.
The Drive is about to operate, meaning there is a danger of
entanglement if anyone is in the drive area. Be sure to verify
that no one is near the drive area, before advancing to the next
step.
Refer to Figure 57
15. Set the three position toggle switch on the Electric
Clutch control box to the “CAL” position.
 This overrides the cam switch located on the
rockshaft allowing the drives to operate while the drill
is in the up position.
The Drive is about to operate, verify the drive area is clear
before advancing to the next step to prevent the danger of
entanglement.
 Press the Down arrow key to exit Calibration Mode if
the drive area is not clear.
Figure 56
Figure 57