2S-2600/F/HD/HDF
Preparation and Setup
Great Plains
| 195-440M | 2019-05-03
23
Shaft Monitor Cab Module
If your drill has the Shaft Monitor option, the cab module
may already have been installed by your dealer. If not,
consult the installation instructions for the option, and
mount the module in a convenient location.
If the cab is particularly noisy, or the operator customarily
wears a noise-canceling headset, the alarms may not be
audible. Mount the module where the status indicators
are visible during planting operations.
Scraper Installation
Optional disk scrapers are not factory installed. To install
them in the field:
1. Remove one or both disk blades to gain safe access
to the mount. Note the position of bushings and
spacers for correct re-assembly (page 59).
2. Position the inside scraper mount to the rear of
the seed firmer mount on the opener weldment.
Secure it with two
3
8
-16x1in hex head bolts, lock
washers and nuts. Insert the bolts from the front.
3. Position the scraper blade below and behind the
inside scraper mount , with the notch on top to
machine right.
Secure it loosely with one
3
8
-16x1 round head
square neck bolt, flat washer, lock washer and nut.
4. Re-mount the removed disk blade.
5. Adjust the scraper blade per “
Figure 14
Shaft Monitor Cab Module
27049
Figure 15
Scraper Installation
26460
2
1
3
