GREAT PLAINS 2S-2600, Operator'S Manual

Page: 28 / 114

Great Plains | 195-440M | 2019-05-03 Table of Contents Index 24
2S-2600/F/HD/HDF Table of Contents Index Preparation and Setup
Press Wheel Scraper Installation
Optional Press Wheel Scrapers may be installed
following these instructions:
1. Use two bolts and nuts to secure press wheel
scraper to press wheel scraper arm .
2. Use U-bolt and nuts to secure the press wheel
scraper arm to the press wheel. Do not over
tighten the scraper so that it may be positioned to fit
the contour of the tire.
3. Remove the bolt from the center of your press wheel
and place the press wheel scraper arm on the
outside of the press wheel. The press wheel arm
should run in approximately the 11 o’clock position
on the outside of the wheel. Replace the center bolt
and tighten.
 There needs to be approximately
1
/
4
inch of a gap
between the press wheel and the press wheel
scraper.
Figure 16
Press Wheel Scraper Installation
TP-71315
2
3
1
1 2
3
2
2