GREAT PLAINS 1510HDP, Operator'S Manual

Page: 46 / 135

Great Plains | 118-949M | 2018-07-03 Table of Contents Index 42
1525P and 1510HDP Table of Contents Index Hydraulic Drive Operation
Refer to Figure 41
37. Continuing to verify that the drive area is clear, press
the ENGAGE button to start drive rotation.
To terminate calibration mode, press the ENGAGE
or OFF buttons.
Refer to Figure 42
38. While the drive is rotating, the display window shows
the time remaining and the “Out” rate.
The “out=” rate is the estimated area planting rate,
based on motor performance, and is not related to
the sample size. The example screen at right is
halfway through the sample collection, and the
actual motor rate is slightly high.
CONTINUE TO MONITOR DRIVE AREA DURING DRIVE
ROTATION. PRESS THE
ENGAGE BUTTON (OR OFF
KEY) TO STOP DRIVE DURING CALIBRATION
Refer to Figure 43
39. When the sample run-time has expired, the motor
stops, the indicator above the ENGAGE button goes
out, and the console displays the estimated sample
generated (based on actual motor performance,
which may vary slightly from calculations).
The number display is normally very close to the
sample size entered at step 31.
Figure 41
Cal. Mode Initiate Motion
28259
Figure 42
Cal. Mode Prompt In Motion
28260
Figure 43
Cal. Mode Normal Completion
28261