IS400 machine
. 28
First contact
Putting the cutter into the spindle
This plate will be engraved using a conical tool (or conical cutter) made of high speed steel with a 4.36 mm diameter and
a 0.50 tip.
12. Lower the spindle until the depth regulating nose touches the material to be engraved
(diagram 31).
Press
ZREF = 0.00 mm
to change
To lower press
13. Open the belt housing of the tool-holder
(diagram 32).
14. Screw knob of cutter
onto the spindle (diagram 32).
The spindle knob should be tightened anti-clockwise (knob with left-hand thread).
The tool is very sharp and to avoid any risks of getting cut, you are advised to use some
kind of protection (gloves) to handle it.
