IS400 machine
. 16
First contact
Electrical connections of the machine
Stand behind the machine (Pict).
1.
Position the control panel beside the machine.
2.
Plug the control panel cable
(1)
into the corresponding socket (N7).
3.
Plug the electronics box to the machine with the cable
(2)
into the correct socket (N1) and (M1).
Tighten the screws using the screwdriver (3.5).
The connectors screws must be very tight to avoid accidental disconnection of the
cables while the machine is turned on as this could permanently damage the electronic
cards (label
).
4.
Plug in the electric cable
(3)
, first to the machine, then to the mains supply.
To cut off the mains supply to your machine in the case of severe problems, unplug the
mains cable (3) or swith off the machine with the stop switch
(I)
at the right side of
the machine. Make sure that you can reach them easily.
As the electrical plug acts as a sectioning device, it is important you set up the machine
so that you always have easy access to the power cable.
The connector
(N2)
(for the cylinder attachment and the pen attachment) and the
connector
(N5)
(for the Automaton function) are also present at the back of the
machine.
Liaison boitier électronique/machine
Electronics-machine connection
Verbindung Elektronikeinheit/Maschine
Tourne Cylindre
Cylinder attachment
Abrollvorrichtung
Broche externe
External Spindle
Externe Spindel
E/S Standard
Standard I/O
E/A Standard
