49
Figure 52
Figure 53
When replacing the Forward-Reverse Clutch unit, the planetary gears must be timed. Time Planetary gears
as follows:
a.
Place Sun pinion in bore of front pin plate.
b.
Secure pin-plate quill to the pin plate with three (3) quill-securing bolts.
c.
Place the orbit gear pins in orbit gears.
Figure 54
Figure 55
d.
Mesh the three gears with Sun pinion so that the timing marks form an equal sided triangle. Timing
marks (A, Figure 57) are small punches on the opposite side of gears.
When replacing this unit in the transmission it is necessary to mesh the teeth on the actuating rod and
the clutch slide rods (See Figure 58) to accept the assembly.
FIRST-SECOND GEAR, CLUTCH AND PLANETARY
To examine the first-second clutch and planetary, remove engine as described on page 44 and releas,
unit by turning the actuating shaft.
