35
10. Starting the charge process Output 2 and 3
For charging / discharging, or conditioning a pack, select the
desired program as described below, and then set suitable
values.
If the battery does have a balancer connector, connect the
balancer connector to the balancer input (BALANCER CON-
NECTOR) of the charger.
Make sure for the right polarity.
From right handed to left side:
Pin 1 (GND): Ground = battery -,
Pin 2 (1): + cell 1, Pin 3 (2): + cell 2, Pin 4 (3): + cell 3
Connect the two pole power charging cable of the battery to the
charger output - B with the right polarity.
Hold the START button pressed in for about two seconds, and
the charger display, if the balancer connector is connected or
not. With connected balancer connector the single cell voltages
can be displayed, see 16..
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
B A T T E R Y C H E C K
W A I T P L E A S E . . .
2 sec.
START
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
L P + 1 2 . 0 V
2 sec.
3 sec.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
* * I N F O R M A T I O N * * *
B A L A N C E R C O N .
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
* * I N F O R M A T I O N * * *
B A L A N C E R N O T C O N
START
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
T y p e O U T P U T[ 2 ]
L i P o = 3 c e l l s
INC
+
-
DEC
If a Li-battery is connected and the balancer
connector is not connected, the charger
will display the cell count of the Lithium
pack, which must be corrected manually,
if it is wrong..
START
2 sec.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
B A T T E R Y C H E C K
W A I T P L E A S E . . .
! Caution ! Please take
great care to set the
correct cell count. and
the right battery type.
If you make a mistake,
the battery could
explode and burst into
fl ames !
Press the START button again, and
the charger will assess the battery.
2 sec.
2 sec.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
T y p e O U T P U T [ 2 ]
L i P o
= 3 c e l l s
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
T y p e O U T P U T [ 2 ]
L i P o
< 0 . 5 A
START
MODE
INC
+
-
DEC
INC
+
-
DEC
Press button Output Select once to switch to terminal [2] or twice for terminal [3].
