37
38
Temperature setup
Alarm setup
Alarm rings at the preset time. The charger continues op-
erating. Tap the STOP button to stop the alarm.
Output voltage setup
With an installed temperature sensor, this feature is controlled au-
tomatically. The preset voltage can be outputted for setups with-
out a temperature sensor. The temperature setup range is 5-15V.
Processing time and temperature
For warmers not equipped with a temperature sensor, the temperature can not be con-
trolled. To warm without a temperature sensor, control the voltage to maintain the desired
temperature of the tires. Please notice that an over voltage setup can cause fires.
- CAUTION -
· Depending on the version of the Air ESC, the throttle stick should be in the low-position.
· Depending on the version of the Car ESC, the throttle stick should be at neutral position.
· The ESC setup is not available while other functions are in operation.
Both the Car ESC and the Air ESC with a telemetry function
can be programmed without an extra programmer. Select the
ESC setup icon. Turn on the model’s power. Then, connect
the telemetry terminal to the EXT. MODULE, allowing the data
to be displayed and programmed. (pages 38-39)
The data can be programmed with 6 buttons.
1. The 3 modes can be accessed by the DEC/INC buttons.
2. The UP/DW buttons are used for the setup only after
the SET button has been touched. Without this toggle,
the UP/DW buttons are used to change the page.
3. The ESC setup page can be exited by touching the ESC
button.
Speed Controller Setting
Connection configuration for the ESC setup (Charger, ESC, Motor, Battery, Receiver included)
Connect the telemetry terminal to the EXT MODULE.
Please note that some ESCs are required to connect the transmitter. Please check the
version of your ESC. After connecting a battery to the ESC, the ESC setup will become
available.
To check the data, connect the telemetry terminal to the EXT MODULE without removing
the batteries.