17 / 20
4318_PN_V1
Glue the rudder horn (33) in
the elevator (29), hook the
cranked end of the elevator
pushrod (32) into the rudder
horn, connect the elevator
(29) with hinged band to the
elevator.
Unhook the elevator pushrod at the front and attach it to the servo lever.
Assembly step 24
Mount the wing onto the
fuselage with the screws
(50). Install and tighten the
propeller. Connect the GR-12
HoTT receiver and insert it
behind the bulkhead (5).
Check all control functions
and bring all control surfaces
into neutral position. The
maximum control surface
excursions are 10 mm at the
aileron and 8 mm at the ele-
vator, measured at the end
edge of the surface. I
t is not indispensable to
paint the model.
To protect the model against moisture, it can be painted 1 to 2 times with GLATTFIX pore filler. Before
and after the painting sand the surface with sanding paper No. 700.1.
Assembly step 25
Insert the battery as shown,
then balance the model. The
weighing takes place in ready
to fly state, ie with mounted
wing. The center of gravity is
measured at 50 mm from
the wing front edge. The
center of gravity is checked
by sustaining the model with
two fingers
at the center of gravity below the wing. The model should then be balanced and levelled. If neces-
sary, move the battery.
Assembly step 26
Remove the individual writings (51) from the carrier foil and stick it to the desired position of the
model. The image on the packaging carton serves as a template. Paint the canopy with a black fiber
pen. Fly the model with neutral control surfaces in calm or light wind. An obstacle-free meadow is
ideally suited as a terrain. Start the model into the air by hand against the wind direction.
GRAUPNER Modellbau wishes many beautiful flights with the
PEP
model
Summary of Contents for PEP 4318
Page 1: ...EN Manual C o p y r i g h t G r a u p n e r S J G m b H No 4318 R Celectricairplane PEP...
Page 2: ......
Page 20: ......
