11 / 20
4318_PN_V1
Assembly step 6
Cut off the ends of the poly-
ester tape protruding below
and cut the tape over the
nuts (13). Try to install the
elevator servo from RC drive
set No. 4318.90 (No. 4318.90
is not included in the quick-
kit No. 4318). To do so, spare
the right-hand reinforce-
ment (8) accordingly. This
process takes place only at
the present time, so that the
reinforcement (8) is rectilin-
ear. The elevator servo can
already be fixed in the fuse-
lage with a few drops of
instant glue. Make sure the
servo is flush with the outer
edge of the fuselage bot-
tom.
Assembly step 7
Pin the fuselage back onto
the construction board with
fixing needles. Then glue
and fix the fuselage side
pieces (15) and (16). Make
absolutely sure that both
sides of the fuselage are
resting exactly on the con-
struction board without any
gaps, and that super glue is
applied in the area of the
polyester tape (14). Insert
the pushrod outer tube (17)
and also glue in with the
instant adhesive.
Assembly step 8
Prepare the fuselage nose
cover (20) for further assem-
bly. To do this, cut out the
field engraved in front with
the balsa cutter according to
the illustration. The recess
should be 5 mm deep, so
that later the motor leads
can have space. Sand the
end edge according to the
leading edge of the wing
Summary of Contents for PEP 4318
Page 1: ...EN Manual C o p y r i g h t G r a u p n e r S J G m b H No 4318 R Celectricairplane PEP...
Page 2: ......
Page 20: ......
