GRAUPNER PEP 4318, Manual

Page: 15 / 20

15 / 20
4318_PN_V1
Assembly step 15
Bevel the leading edge of
the reinforcement (41)
before sticking.
Then stick together with the
holes in the wing (35).
Check that the end edge is
parallel to the wing leading
edge and check the triangle
ruler.
Lower the holes for the screws (50) so that the screw heads do not protrude.
Assembly step 16
Cut off the end strips (38/39)
and glue them on, the under-
side should rest flat.
Then align the end strips
(39) to the contour of the
winglets.
Sand the top of the wing using the fine-grained side of the sanding block (54).
Assembly step 17
Glue the winglets (37) to the
wing by firmly attaching the
wing to the building board.
Loosely insert the ailerons
(40).
The V-shape of the winglets is 15 ° corresponding to 35 mm, measured at the end of the wing. When
the wood glue has hardened, sand the wing using the fine-grained side of the sanding block (54).
Assembly step 18
Glue the servo covers (42)
and (45) together and glue
them to the fastening straps
with a few instant glue.
Cover the servo housing
with adhesive tape so that it
will not be damaged when
sanding the balsa wood
parts. Unscrew the servo
lever. Streamline and sand
the panels.
Assembly step 19
Chamfer part (47) at the
back and glue on, put on
part (46) only loosely, as well
as the covered servos, mark
the contour of (45) on part
(46), saw it off, match the
front edge and stick on the parts (45) for part (46) below, then glue the servos.