GRAUPNER HoTTrigger 1400S, User Manual

Page: 13 / 164

13
innovation & technology
12
2015/02/12
EN
Speed controller
Weight with cables 43 g
Brake programmable
Continuous current at 25°C 40 A
Peak current for 10 sec. 55 A
Cell count LiPo, Lilo: 2 - 4
Operating voltage 7,4 - 16,8 V
Dimensions 65 x 25 x 12 mm
BEC receiver output: 5 V / 4 A
Servos operating voltage 4,8 - 6 V DC
Servos max. 4
Controller 40 A
Max. RPM 2 Pole 210000 T/min
Max. RPM 6 Pole 70000 T/min
Max. RPM 12 Pole 35000 T/min
Automatic under-voltage cut-off YES
Automatic overheating cut-off 110 °C
Automatic motor stop if signal lost YES
Controller technical specifications
Commissioning of the controller
Note:
The controller can be operated with different transmitters from different manufacturers, to ensure the
optimal operation it is necessary to set the controller to your transmitter.
1. Move the throttle stick to the full throttle position and connect the battery, the motor plays a melody like “Do Re Mi“.
2. After 2 sec. the motor emits 2 long beeps (B-- B--) then the controller has detected the full throttle position. Move
within the next 2 sec. the throttle stick to the stop position, after the tones (B-- B--) the controller detects the stop
position.
3. After a long (B--) the setting is complete and the controller is ready to start.
Programming the controller through the gas stick
1. Move the throttle stick to the full throttle position and connect the battery, the motor plays a melody like “Do Re Mi“.
2. After 2 sec. the motor emits 2 long beeps (B-- B--) then the controller is in programming mode. Move within the next
2 sec. the throttle stick to the stop position, after the short tone (B) the controller has detected disabling the brake.
3. After a long (B--) and a short (B) the setting is complete and the controller is ready to start.
Disabling the brake
1. Move the throttle stick to the full throttle position and connect the battery, the motor plays a melody like “Do Re Mi“.
2. After 2 sec. the motor emits 2 long beeps (B-- B--) then the controller is in programming mode. Wait for the tone
short (B) from the brake disabled then follows the sound with 2 short (BB) activates the brake. Move within the next
2 sec. after the short tone (BB) the throttle stick to the stop position, the controller has detected the activation of the
brake.
3. After a long (B--) and a short (BB) the setting is complete and the controller is ready to start.
Activate the brake