GRAUPNER/SJ GmbH 73230 KIRCHHEIM/TECK GERMANY
Subject to modification! No liability for printing errors!
03/2018
-
6
-
refine, pierce and sand them accordingly. When assembling, always pay attention to
a clean, smooth surface. Unless otherwise specified, use UHU-hard as an adhesive,
wipe off excess adhesive with absorbing paper. If necessary, fix the components with
fixing needles or adhesive tape until the adhesive has hardened.
Fuselage and rudder
Lay the building plan 1 on the building board and cover the area of the fuselage side
with a clear plastic film so that the components do not stick to the plan. Glue the right
side of the fuselage (1 and 2), stuck together with the drawing of the construction
plan. Glue the fuselage belt (3) exactly flush with the outer edge of part (1 and 2).
The left side of the fuselage must also be glued to the building plan. It is important to
note that the left side of the fuselage has to be removed from the base again so that
the back fuselage belt can be glued.
