GRAUPNER/SJ GmbH 73230 KIRCHHEIM/TECK GERMANY
Subject to modification! No liability for printing errors!
03/2018
-
5
-
General
The
AMIGO V
model is a classical
Graupner
airplane model
that achieves
challenging flight performance. It is particularly characterized by a low airspeed and
best thermal airing properties. The design was based on the version AMIGO II from
1966. The wing and tail unit adopted are exactly like the original ones. The model
can start with a rubber-system, but it can optionally be flown with a motor set as a
motor glider. The construction of the model requires manual modelling skills and
should only be carried out or supported by experienced model builders.
Suggested accessories
(not included)
mz-12 PRO HoTT DE
No. S1002.PRO.DE
Servo DES 577 BB (2 pcs required)
No. 7944
Receiver battery 4N-1600 NiMH JR 2/3
No. 8716.4
Power supply cable with charging connector
No. 3934.3
LiPo battery charger ULTRAMAT 14 plus
No. 6464
Charge cable for JR receiver battery
No. 3021
Required tools and adhesives
(not included)
UHU hart
No. 534.35
UHU Kraftkleber superstark
No. 1096
Adhesive tape
No. 531.19
CA glue
No.5821
Activator for CA glue
No. 953.150
Balsa cutter
No. 980
Balsa plane
No 737
Sandpaper grain 320
No. 700.1
Fixing needles
No. 717
Curved scissors
No. 26
Brush
No. 208
Phillips screwdriver PH 2
No. 5779.2
Hexagonal ball head screwdriver 2,5 mm
No. 5777.2,5
Building surface of soft wood, pencil, ruler, jigsaw, sanding block 100, flat nose pliers,
scissors, drills Ø 2 and Ø 4 mm, absorbing paper, clear film, weights, water spray
bottle.
Required adhesives and tools
(not included)
SPANNFIX Spannlack farblos (5 pcs required)
No. 1408.1
SPANNFIX Spannlack red (2pcs required)
No. 1408.2
SPANNFIX Verdünnung (2 pcs required)
No. 1409
UNIVERSALLACK black
No. 921.7
JAPICO MODELSPAN cover paper white (2 pcs required)
No. 524.11
JAPICO MODELSPAN cover paper white (4 pcs required)
No. 524.19
Building instructions
Before starting the construction, please consult the building instructions together with
the building plan, so that you can get an overview of the sequence of the assembly.
Group the prepared components, tools and adhesives for a construction stage.
Remove the individual wood parts with the balsa cutter from the boards, if necessary
