13
fabric tape (160 g) and resin over a length of 50 – 60 mm. be sure to roughen the
joints with sandpaper (80 grain) before bonding with a suitably thickened epoxy resin
– as shown.
When mounting the canopy to the fuselage, place the canopy onto the fuselage so
that the GRP-tongue on the rear end can firstly be pushed so far into the fuselage
that the steel pin will be pushed under the fuselage section when the canopy is
pushed forward again.
When being pushed forward the canopy self-centres automatically in the canopy
frame on the fuselage.
To install the servo tray, start by tearing off the fabric tapes on the inside of the
fuselarge.
