11 / 28
S5012_Alpha_110_jh_V1
TEST VERSION, DO NOT USE FOR PRINTING
Charging copter's battery
Plug the USB connector of the included charger to a suitable 5
V port.
1. The LED on the charger will light green.
2. Plug the battery connector to the charger charging port.
3. The LED will turn from green (stand by mode) to red (charge
mode).
When the charge process has finished, the LED lights on green
again. Then is the battery fully charged.
4. Unplug first the battery connector from the battery charger
and then the USB cable from the power supply.
Transmitter power supply
The
mz-8
HoTT transmitter is normally delivered with three alka-
line batteries.
The transmitter battery voltage is monitored by a status LED
during operation.
If the voltage drops below 3,2 V, an acoustic alarm will sound
and the red status LED starts to blink quickly. Now at the latest,
stop operation and change the transmitter batteries!
Inserting the transmitter batteries
To insert the transmitter batteries remove the battery case cover
on the back side of the transmitter. Insert the included batteries
in the holder paying attention to the correct polarity (see figure)
Removing the transmitter batteries
If the transmitter is not going to be used for a long time, the bat-
teries should be removed from the device to avoid damages to
the transmitter due to electrolyte leaks.
