8
Using the charger for the first time
Using the charger for the first time
Using the charger for the first time
Connect the power supply a easily accessible mains
socket near to the charger, when using the 100 - 240
V AC power input, if a main socket is available.
Connect the charger to 11 - 16 V DC with minimum
1.2A or to the power supply output 15V / 800mA.
The green and red LED of the charger are lighting,
1 second later they will be off. Now you can connect
the battery 2S or 3S (2 or 3 cells) balancer connec-
tor Graupner-EH to the charger.
You must not charge 2 cells and 3 cells at the same
time!
Make sure for the right polarity of your battery
balancer connector Graupner-EH.
From right handed to left side:
Pin 1 (GND): Ground = battery -,
Pin 2 (1): + cell 1
Pin 3 (2): + cell 2
Pin 4 (3): + cell 3
Contact 2 or 3 cells to the charger output correctly,
make sure, positive is on the left side and negative
on the right side.
Red LED on, green LED off means charging.
If the battery is charged full, the green LED is on and
the red LED is off.
Notes
•
Contact AC power first, before contact to the
charger.
•
Move charger away after charging, do not contact
charger with battery after charged full.
•
Finished charging, take off the charger from AC
power.
•
Do not put something on it during charging.
•
Working Temperature is from 0 to 40°C, the better
charge performance is at 10 to 30°C.
•
If the single cell voltage difference of 2S or 3S is
bigger, the charge time may be longer.
•
AC power supply should be only the original one
or 15V 1.2A
•
If the DC power is less then 10V, the charger can
not work.
•
Before using, customers must read this manual.
Any accident lead by incorrect using method (other
then specified), manufacturer, distributor, retailers
will not be responsible.
INPUT
10-18V DC
OUTPUT
2 LiPo-cells
or 3 LiPo-cells
INPUT 100~240V AC
LED red charge
FOR INPUT 10-18V DC
LED grün ready
INPUT
10-18V DC
