GRAUPNER 4831.660, Manual

Page: 20 / 42

Code 51
Phase adjust
Programming of flight phases
List of flight phase dependant menus for
helocopter models:
Page Code Name
mc-24/1 here
32 »Control adjust« 49 18
33 »Dual Rate/Expo« 54 -
34 »Channel 1 curve« 58 -
51* »Phase adjust«* 67 23
53 »Phase trim« 68 (27)
Phase 1 0.0s
Phase 2 0.0s -
new functions 22
58 »Non delayed channels« - 28
71 »Heli mixer« 77 -
73 »Mix aktive /phase« 96 -
82 »Profi trim« 102 -
The page display mc-24/1 is relative only to the
MEGA-SOFT-ROM hand book.
*
Code 51 was changed from »Phase assignment« to
»Phase adjust«. The old Code 52 »Phase trim« has now the
number 53 in the PROFI-ROM and chan
Please note the details and change in page 26
ged functions.
).
anges in
will affect all flight phases. If
ry you can remove menus which can not
(
All other menus are model dependant and not
programmable for each flight phase. Ch
all other menus
nesecca
be changed in Code 13 »
Suppress codes «
during programming of the flight phases in the
multi function list.
Phase 3 0.0s -
eit
Phase 4 0.0s -
Name Flugph. Uhr Umsch. Z
SEL SEL SEL
ses“.
In each model memory offers the mc-24 PROFI-
ROM the possibility of up to 8 independant
adjustments for different flight circumstances -
ormaly called “flight pha n
Begin the programming for “
flight phases “ here in
Code 51 by allocating a name and maybe a timer
and delay time for change
to the phase.
Next step is to select the neccessary “Phase
nt switches“ in the ne «
If a switch is alread
Symbol Discription
w Code 52 » Phase assignme
y been allocated for any of the
phases 1-8 you will see it indicated in the right
column:
- No switch planned
+ Phase recall via switch
∗
Marks the phase number allocate
the switch position d to
Hint:
Of help during programming of the various flight
phases is the command “Copy flight phase“ in Code
12 »copy/erase«. First all parameters for a flight
phase are established and than copied into the next
flight phase where they can be modified to suit the
new flying mode.
“Name“: Press the SEL -key and use the rotary
selector to choose a name from the list
for the required phases.
You can, apart from using the normal
phase names also create your own
names in Code 91 »
Basic settings «
( see further below ).
The sequence of phases 1 to 8 is not
critical and does not have to be continuos.
But you begin always with “phase 1“ the
“normal phase“ which is always active
when
•
in Code 52 no phase switch is set
re
eutral and serve
ntification only for the further
enus is
•
no switch combinations exist
•
all phase switches are in default
position.
The phase name “normal“ could therefo
be logical for “phase 1“.
The names are program n
as ide
programming of flight phases and hence
they are displayed in all flight phase
dependant menus and in the default
display.
A list of flight phase dependant m
shown further above.