GRASS VALLEY PERFORMER, Instruction Manual

Page: 111 / 182

2-79
Control Panel Reference
XYCP (XY Control Panel) Switch Settings
The switches on the XY Control Panel determine levels controlled,
panel address, and destination of control (default) just as did the
MBCP; the MBCP instructions may be followed except with
regard to the lower two segments of the LEVELS switch. Segment
8 of the LEVELS switch selects NORMAL (control and tally)
operation or STATUS ONLY (tally, no control) operation. The XY/
ALL LEVEL segment allows you to use the panel as an XY or as
an All Level control panel. In All Level Mode, the controlled
destination is displayed but its levels cannot be changed
independently by front panel entry.
Serial Interface Switch Settings
NOTE: The Serial Interface discussed here is the TEN–20/20–
TEN SERIM used to interface a computer or external control
panel to the RS485 bus.
The Serial Interface translates between an external RS232 or
RS422-capable control device and the RS485 bus, allowing the
external device to masquerade as a Performer or 20–TEN control
panel. Switches on the back of the Serial Interface determine levels
of control, RS232 or RS422 standard, panel number, and serial port
baud rate, parity, and number of data bits.
Grass Valley Group
LEVEL 1 LEVEL 2 LEVEL 3 LEVEL 4 DESTINATION
PROTECT
TAKE
CLEAR
LAST
0 1 2 3 4
5 6 7 8 9