GRAPHTEC SignJet JS310-25ES, Service Manual, Page: 95 / 141

9. Procedures when leaving the printer for a long time
88 JS310-UM-251-9370
9.2 Induction of the cleaning solution
(1) Pour 150 to 200 cc of cleaning solution into each ink tank.
Pour 150 to 200 cc of cleaning solution into each of the four ink tanks (C, M, Y, K).
• 150 to 200 cc guideline amount: The level where the filter in the ink tank is covered.
(2) Turn on the printer power supply.
(a) The ink pump operates to feed the cleaning solution to the sub tanks.
(b) If the “
No ink ” alarm sounds, from the main menu, select [ Ink Status ] and then press the ENTER key.
(c) The alarm will stop sounding when the four sub tanks (C, M, Y, K) are filled with cleaning solution.
(d) At this time there will be no operating noise from the ink pump.
(3) Move the printhead carriage to the cleaning position.
(a) From the main menu, select [ Cleaning Tool ] and then press the ENTER key.
(b) From the submenu, select [
Clean Post
] and then press the
ENTER
key.
(c) The printhead carriage moves to the cleaning position and then stops.
(4) Feed out any cleaning solution through the Print Head nozzles.
(a) Press the Ink button to feed out any cleaning solution through the Print Head nozzles.
(b) Continue to feed the cleaning solution through the Print Head nozzles until they are clean (approximately
20 seconds).