3-3
3.2 Loading a Document
How to use the document guides
Insert the document (the surface to be scanned) face up into the scanner until the top edge of the
document contacts the feed rollers. At this time, make sure that the document is straight and that it is
centered in the scanner.
(1) With the top cover in the closed status, turn on the scanner’s power supply.
(2) The document guides are attached to the document-scanning table via magnets. Place them at
the edges of the document in alignment with the document width.
(3) Place the document between the document guides, and then insert the document into the gap
between the top cover and the document-scanning table, making sure that it is straight.
(4) When the preset delay time speci
fi
ed in the driver software has elapsed, the rollers start turning
to automatically feed the document to the position to start scanning. The document is now loaded.
(Manual loading: OFF)
(5) Remove the document guides after you have loaded the document in order to ensure that the
document does not get damaged if it is fed at an angle.
Remove the document guides after the document has been loaded correctly. If the document
guides are not removed, the document might get damaged when it s being fed.
Document to be scanned
Document-scanning table
Top cover
Document guides
There are two document setting modes available.
(For more information, refer to "Section 3 Scanning Settings" of the "Scanning Master Pro
Color ‘OPS115’" Instructions Manual (PDF))
• The rollers start turning at a preset delay time after the document has been inserted
so that they automatically feed the document to the position to start scanning. (Manual
loading: OFF)
• The rollers start turning when the [EJECT] key on the control panel is pressed after a
document is inserted so that they automatically feed the document to the position to start
scanning. (Manual loading: ON)
If you want to reload the document, press the [EJECT] key to eject the document. Reload
the ejected document.
When the document has been loaded, the [PAPER] LED (green) lights.
Checkpoint
If the PAPER LED does not light after the document feed operation has stopped, press
the EJECT key, and the document gets reset without being ejected and the PAPER LED
lights.
Caution
• If the document is inserted at an angle, the image may be scanned in at an angle or a
scanning error may occur. Make sure that the document is aligned with the document
guides when it is inserted.
• The delay time (automatic feed time) after the scanner has been turned on is set to three
seconds.